Model TMS69BL9813
Installation and operation instructions for the TMS69BL9813 saddlebag lid speaker kit.
| Model | TMS69 |
|---|---|
| Description | 2-Way |
| Nominal Impedance (Ohms) | 4Ω |
| Frequency Response (Hz) | 56-20kHz |
| Power Handling - Watts (RMS/Peak) | 100/200 |
| Fs - Free Air Resonance (Hz) | 75 |
| Qts | 1.63 |
| Sensitivity (1W/1M) | 89dB |
| Sensitivity (2.83V/1M) | 92dB |
| Grille/Trim Ring | NO |
| Warranty - All marine, motorcycle, motorsport products | 2 Years |
Source: Installation & Operation Manual, Rockford Fosgate. Wording and values are retained from the supplier document.
The complete text of the Installation & Operation Manual for TMS69BL9813 (8 pages), extracted from the supplier PDF; pages without a text layer were transcribed from the page image. Check wiring and settings against the original PDF before cutting or splicing.
Installation assistance available at: RFTECH www.rockfordfosgate.com/rftech 1998 - 2013 H-D SADDLEBAG LID SPEAKER KIT TMS69BL9813 600 South Rockford Drive • Tempe, Arizona 85281 United States Direct: (480) 967-3565 • Toll Free: (800) 669-9899 ROCKFORDFOSGATE.COM 072717 1230-61983-01-A Printed In China Installation & Operation
Introduction
Dear Customer, If, after reading your manual, you still have questions regarding this
Congratulations on your purchase of the world’s finest brand of product, we recommend that you see your Rockford Fosgate dealer.
audio products. At Rockford Fosgate we are fanatics about musical If you need further assistance, you can call us direct at 1-800-669-
reproduction at its best, and we are pleased you chose our product. 9899. Be sure to have your serial number, model number and date of
Through years of engineering expertise, hand craftsmanship and critical purchase available when you call.
testing procedures, we have created a wide range of products that
reproduce music with all the clarity and richness you deserve. PRACTICE SAFE SOUND
For maximum performance we recommend you have your new Continuous exposure to sound pressure levels over 100dB
Rockford Fosgate product installed by an Authorized Rockford Fosgate may cause permanent hearing loss. High powered auto
Dealer, as we provide specialized training through Rockford Technical sound systems may produce sound pressure levels well
Training Institute (RTTI). Please read your warranty and retain your over 130dB. Use common sense and practice safe sound.
receipt and original carton for possible future use.
Great product and competent installations are only a piece of the puzzle
when it comes to your system. Make sure that your installer is using Safety
100% authentic installation accessories from Rockford Fosgate in your This symbol with “WARNING” is intended to
installation. Rockford Fosgate has everything from RCA cables and alert the user to the presence of important
speaker wire to power wire and battery connectors. Insist on it! After all, instructions. Failure to heed the instructions
your new system deserves nothing but the best. will result in severe injury or death.
To add the finishing touch to your new Rockford Fosgate image order This symbol with “CAUTION” is intended to
your Rockford accessories, which include everything from T-shirts to alert the user to the presence of important
hats. instructions. Failure to heed the instructions
Visit our web site for the latest information on all Rockford products; can result in injury or unit damage.
www.rockfordfosgate.com • To prevent injury and damage to the unit, please read and
or, in the U.S. call 1-800-669-9899 or FAX 1-800-398-3985. For all other follow the instructions in this manual. We want you to enjoy
countries, call +001-480-967-3565 or FAX +001-480-966-3983. this system, not get a headache.
• If you feel unsure about installing this system yourself, have
Table of Contents it installed by a qualified Rockford Fosgate technician.
2 Introduction • Before installation, disconnect the battery negative (-)
terminal to prevent damage to the unit, fire and/or possible
3 Installation injury.
4 Warranty
©2017 Rockford Corporation. All Rights Reserved. ROCKFORD FOSGATE and associated logos where applicable are registered
trademarks of Rockford Corporation in the United States and/or other countries. All other trademarks are the property of their respective
owners. Specifications subject to change without notice.
2Specifications
Model TMS69
Nominal Diameter - inch 6x9
(mm) (152 x 229)
Description 2-Way
Nominal Impedance
4Ω
(Ohms)
Frequency Response (Hz) 56-20kHz
Voice Coil Diameter - 1.4
inch (mm) (35.6)
Power Handling - Watts
100/200
(RMS/Peak)
Fs - Free Air Resonance
75
(Hz)
Qts 1.63
Vas - cu. ft. 0.593
(Liter) (16.8)
Sensitivity (1W/1M) 89dB
Sensitivity (2.83V/1M) 92dB
Xmax - inch 0.12
(mm) (3)
8.7 x 5.8
Mounting Diameter
(218 x 147)
2.8
Mounting Depth
(71)
Grille/Trim Ring NO
See page 4 for additional dimensions
CEA 2031
Power handling on Rockford Fosgate speakers conform to CEA-2031 industry standards. This means your speaker has the
capacity to handle power under continuous demand, not instantaneous power handling that over time can damage voice coils.
VERIFIED WITH KLIPPEL
To adorn the ‘Verified with Klippel’ mark, the qualifying company’s loudspeaker engineering personnel must be trained and
certified by Klippel prior to using the three separate Klippel systems to design, develop and test. Rockford Fosgate has made the
investment in Klippel to deliver the best possible speakers and subwoofers to their customers.
3Specifications TMS69 9.2” (234mm) 6.5” (165mm) 6.4” (163mm) 4.7” (120mm) 3.2” (81mm) 2.8” (70mm) 3.2” (81mm) 2.8” (70mm) 8.6” (218mm) 5.6” (147mm) 4
Installation
Contents Applicable Models:
• (2) TMS69 Speakers • (1) Main Harness
1998 to 2013 Harley-Davidson® Motorcycles with Factory
• (2) Speaker Grilles • (2) Saddlebag Harnesses Saddlebags
• (2) Mounting Rings • Plastic Wire Tie Wraps This saddlebag lid speaker kit is designed to work with Rockford
Fosgate’s compact chassis Punch® and Power series amplifiers.
• (2) Cutting Templates • Plastic Cable Tie Mounts
Step 1. Remove the saddlebag lids, seat, gas tank and fairing cover
• (16) Mounting Screws
from the motorcycle.
Installation Tools Step 2. Using masking tape, tape over the painted portion of your
The following is a list of suggested tools needed for installation: saddlebag lids.
• Drill • Small Flat Blade Screwdriver NOTE: This will prevent any scratching of the factory paint during the
installation process.
• Jigsaw / Airsaw • Phillips Screwdriver
• 1/8" Drill Bit • Torx Drivers NOTE: Be sure the template sits snug on all sides and corners of the
saddlebag lid before securing.
• 5/16" Drill Bit • Socket set
• 3/4" Hole Saw • Masking Tape Screw Locations
• Wire Cutters
Installation Considerations
This section focuses on some considerations for installing your Harley-
Davidson® saddlebag lid speaker kit.
If you feel unsure about installing this system yourself, have it installed
by a qualified technician.
When drilling holes, make sure what is on the other side. Be sure that
any electrical, fuel lines or any other important components are free
and clear from the area.
Before installation, disconnect the battery
negative (-) terminal to prevent damage to Apply Tape
the unit, fire and/or possible injury.
Before beginning any installation, follow
these simple rules:
Be sure to carefully read and understand
the instructions before attempting to install
these speaker kits.
• Consult your motorcycle’s service manual for model specific
information. Models may differ from year to year depending on
factory options and aftermarket accessories added.
• This speaker kit is specifically designed to work with Rockford Step 3. Apply the template to the saddlebag lid and secure using (2)
Fosgate’s Punch® and Power series compact amplifiers. screws that came with the kit.
• With the addition of an amplifier or source unit, be sure that your NOTE: There is a brake and clutch side specific template for each lid. You
current charging system is in proper working order. can use an 1/8" drill bit to predrill holes before screwing the template to
• Visit rockfordfosgate.com for more comprehensive product the lid. Be sure the template is secured and wont move.
information. Step 4. Once the template is secured, use a 5/16" drill bit and drill
• Visit our YouTube channel for comprehensive installation videos holes in the template.
demonstrating complete installation guides and install tips. NOTE: We suggest drilling at every segment to make sawing easier.
Step 5. Using a jigsaw, follow along the template.
NOTE: DO NOT cut the segments of the template until all of the slots
have been cut. This will help maintain accuracy and fitment for the
grilles.
NOTE: When cutting, be sure that the saw blade stays in between the
edges of the template. Cutting into the template will lead to fitment
issues.
Step 6. Next you will attach the speaker, grille and mounting ring to
the lid using the supplied screws.
5Installation
Speaker
Grille
Saddlebag
Lid
NOTE: It is easiest to place the grill into the hole that has been cut into
the lid and place upside down on a bench. Then place the appropriate
mounting ring onto the grille, along with the speaker. Secure with the
Mounting supplied screws.
Ring
Step 7. Run the main harness up the back bone of the bike and to the
amplifier under the fairing.
Step 8. Drill a 3/4" hole on the inside of the bag for the saddlebag
harness. Once the hole is drilled, insert through the hole and
secure the grommet.
Step 9. Place the adhesive backed plastic cable tie mounting tab to
the inside of the bag.
Speaker
Mounting
Screw Plug or
Connector
Cable
Clamp
Step 10. Route the wire along the inside of the bag and secure to the
plastic cable tie mounting tab with the supplied plastic wire
ties.
Step 11. Reattach your saddlebag lid and connect the harness to the
speaker.
Step 12. Test system and reassemble the motorcycle.
67
Warranty
Rockford Corporation offers a limited warranty on Rockford Fosgate products on the following terms:
Length of Warranty
POWER Amplifiers – 2 Years
BMW® Direct Fit Speakers – 2 Years
PUNCH® & PRIME® Amplifiers – 1 Year
Speakers, Signal Processors, Accessories and Capacitors – 1 Year
All marine, motorcycle, motorsport products - 2 Years
Any Factory Refurbished Product – 90 Days (receipt required)
What is Covered
This warranty applies only to Rockford Fosgate products sold to consumers by authorized Rockford Fosgate dealers in the United States of America.
Products purchased by consumers from an Authorized Rockford Fosgate Dealer in another country are covered only by that country’s Distributor and
not by Rockford Corporation.
Who is Covered
This warranty covers only the original purchaser of Rockford product purchased from an authorized Rockford Fosgate dealer in the United States. In
order to receive service, the purchaser must provide Rockford with a copy of the receipt stating the customer name, dealer name, product purchased
and date of purchase.
Products found to be defective during the warranty period will be repaired or replaced (with a product deemed to be equivalent) at Rockford’s
discretion.
What is Not Covered
1. Damage caused by accident, abuse, improper installation, operations, theft, water (on non-Element Ready products).
2. Any cost or expense related to the removal or reinstallation of product.
3. Service performed by anyone other than Rockford or an authorized Rockford Fosgate service center.
4. Any product which has had the serial number defaced, altered, or removed.
5. Subsequent damage to other components.
6. Any product purchased outside the U.S.
7. Any product not purchased from an authorized Rockford Fosgate dealer. Refer to rockfordfosgate.com dealer locator for more detail.
Limit on Implied Warranties
Any implied warranties including warranties of fitness for use and merchantability are limited in duration to the period of the express warranty set
forth above. Some states do not allow limitations on the length of an implied warranty, so this limitation may not apply. No person is authorized to
assume for Rockford Fosgate any other liability in connection with the sale of the product.
How to Obtain Service
Please call 1-800-669-9899 for Rockford Customer Service. You must obtain an RA# (Return Authorization number) to return any product to Rockford
Fosgate. You are responsible for shipment of product to Rockford.
EU Warranty
This product meets the current EU warranty requirements, see your Authorized dealer for details.
8